HP LASERJET ENTERPRISE 700 COLOR MFP M775dn - Page 242

Fuser gear assembly
Before proceeding, remove the following assemblies:
●
Fuser. See
Fuser on page 9.
●
Control-panel assembly. See
Control-panel assembly on page 5.
●
Intermediate transfer belt. See
Intermediate transfer belt on page 7.
●
Left cover. See
Left cover on page 55.
●
Rear cover. See
Rear cover on page 56.
●
Right rear cover. See
Right rear cover on page 57.
●
Toner collection unit (TCU) access door. See
Toner collection unit (TCU) access door on page 58
●
Optional: Document feeder. See
Document feeder on page 69.
NOTE: HP recommends removing the document feeder to decrease the weight of the scanner
assembly when it is lifted off of the product.
●
Scanner assembly. See
Scanner assembly on page 72.
●
For a stapler/stacker model:
◦
Stapler/stacker assembly. See
Stapler/stacker assembly on page 76.
●
For a non stapler/stacker model:
◦
Output cover. See
Output cover; non stapler/stacker model on page 91.
●
Front upper cover. See
Front upper cover on page 81.
●
Front right cover. See
Front right cover on page 84.
●
Output cover. See
Output cover; non stapler/stacker model on page 91.
●
Top cover. See
Top cover on page 93.
●
Residual toner full sensor. See
Residual toner full sensor on page 120.
●
First transfer high-voltage PCA. See
First-transfer high-voltage power supply on page 179.
●
Fuser motor M4. See
Fuser motor M4 on page 147.
212 Chapter 1 Removal and replacement ENWW
DRAFT