2. Fasten the replacement fuser drive assembly to the product with four screws. Install the screws in
the order shown below (callouts 1 to 4).
Figure 1-291 Install a replacement fuser drive assembly (2 of 3)
1
2
3
4
3. Replacement fuser drive assembly: Release two tabs in the order shown below
(callouts 1 and 2). and then remove the spacer (callout 3).
Original fuser drive assembly: Installation complete—this step is not required.
Figure 1-292 Install a replacement fuser drive assembly (3 of 3)
1
2
3
ENWW
Main assemblies
211
To Next Page
Loading...