2. Remove one screw (callout 1), and then remove the left tray pickup assembly (callout 2).
TIP: When removing the screw (callout 1), hold the left tray pickup assembly so that you do not
drop the assembly.
Figure 1-392 Remove the HCI left tray pickup assembly (2 of 2)
2
1
Reinstall the HCI tray pickup assembly
To reinstall the assembly, place it in the HCI, and then rotate it up and into position.
Figure 1-393 Reinstall the HCI tray pickup assembly
1
2
ENWW
Input devices
293
To Next Page
Loading...