Reinstall the HCI tray pickup assembly
The tabs at the top of the HCI merge assembly fit into slots provided in the chassis (callout 1).
Figure 1-399 Reinstall the merge assembly (1 of 2)
1
When the assembly is correctly installed, two sheet metal tabs (callout 1) are positioned in the provided
holes in the chassis, and the assembly fits tight against the edge of the chassis (callout 2).
Figure 1-400 Reinstall the merge assembly (2 of 2)
1
2
298 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...