Output devices
Stapler/stacker
NOTE: The stapler/stacker is shown removed from the product in this section, however, it is only
necessary to remove the stapler/stacker from the product to perform the following procedures if the
front right cover must be removed.
To remove the stapler/stacker, see
Stapler/stacker assembly on page 76.
Stapler/stacker rear cover
1. Open the right door.
2. Remove two screws (callout 1).
Figure 1-401 Remove the stapler/stacker rear cover (1 of 3)
1
ENWW
Output devices
299
To Next Page
Loading...