Stapler/stacker output bin assembly
Before proceeding, remove the following assemblies:
●
Stapler/stacker rear cover. See
Stapler/stacker rear cover on page 299.
●
Stapler/stacker left rear cover. See
Stapler/stacker left rear cover on page 305.
Remove the stapler/stacker output bin assembly
1. Disconnect two connectors (callout 1), and then release the wire harnesses from the retainer
(callout 2).
Figure 1-411 Remove the output bin assembly (1 of 2)
2
1
306 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...