Stapler/stacker operation assembly
Before proceeding, remove the following assemblies:
●
Stapler/stacker front right cover. See
Stapler/stacker front right cover on page 301.
●
Stapler/stacker rear cover. See
Stapler/stacker rear cover on page 299.
●
Stapler/stacker left rear cover. See
Stapler/stacker left rear cover on page 305.
●
Stapler/stacker output bin assembly. See
Stapler/stacker output bin assembly on page 306.
●
Stapler/stacker lower left cover. See
Stapler/stacker left lower cover on page 308.
Remove the stapler/stacker operation assembly
1. Open the stapler/stacker right door to move the stapler assembly out of the way.
2. Disconnect six connectors (callout 1), and then release the wire harnesses from the retainers
(callout 2).
Figure 1-414 Remove the stapler/stacker operation assembly (1 of 2)
2
1
ENWW
Output devices
309
To Next Page
Loading...