Reinstall the scanner front cover
1. When the cover is reinstalled, the tab (callout 1) on the end of the cover must fit under the scanner
right cover (callout 2).
Figure 1-77 Reinstall the scanner front cover (1 of 3)
2
1
2. Rotate the cover into place along the control-panel cavity (callout 1 and callout 2), and then push
on the cover to seat the tab on the end of the cover under the scanner right cover (callout 3).
Figure 1-78 Reinstall the scanner front cover (2 of 2)
2
1
3
ENWW
Covers, doors, and whole unit replacement
53
To Next Page
Loading...