Hardware integration pocket (HIP) is not functioning (control panel functional)
Figure 2-6 Hardware integration pocket (HIP) is not functioning (control panel functional)
Hardware integration
pocket (HIP)
not functional
(control panel
functional)
Check that all installed hardware integration
pocket devices are within HP specifications.
The control panel provides only 0.5 Amps to
the port. If an installed device attempts to draw
more power than is provided, the port is
automatically disabled. Troubleshoot third-party
devices with the device manufacturer.
Scanning subsystem
Calibrate the scanner
Use this procedure to properly position the copied image on the page.
TIP: This adjustment might be required after the scanner or document feeder is replaced.
1. From the Home screen on the product control panel, scroll to and touch the Device Maintenance
button.
2. Touch the Calibration/Cleaning button.
3. Touch the Calibrate Scanner button, and then follow the instructions provided on the screen.
136 Chapter 2 Solve problems ENWW
To Next Page
Loading...