Step three: Configure the Stapler/Stacker settings
1. Click the General tab.
2. In the left navigation pane, click the Control Panel Administration Menu link.
3. In the Control Panel Administration Menu area, expand the Administration list.
4. Click the Stapler/Stacker Settings link. Select the item settings to configure:
●
Operation Mode drop-down menu: Mailbox or Stacker mode
●
Stapling drop-down menu: select the position and number of staples. The following staple
options are available:
◦
None
◦
Top left
◦
Top right
◦
Two left
◦
Two right
◦
Two top
◦
Two top or left
●
Staples are very low drop-down menu: select to Continue or Stop from the drop-down menu
●
Job Offset drop-down menu: select On or Off from the drop-down menu
●
Low-humidity Printing drop-down menu: select Enabled or Disabled
ENWW Configure the product for Mailbox Mode or Stacker Mode 77
To Next Page
Loading...