Figure 1-126 Components of the stacker unit control system (2 of 2)
Stacker controller PCA
Second tray paper detection sensor (PI 43) TRY2-P
First tray paper detection sensor (PI 42) TRY2-P
Delivery path paper detection
sensor (PI 34) TIMING
Inlet paper detection sensor (PI 33) INLET
Booklet-maker-unit control system
●
The paper-output mechanism keeps paper from the stacker unit in place for stapling and folding.
●
The No. 1 flapper and the No. 2 flapper of the paper inlet configure the paper path to fit the
paper size.
●
The paper-positioning plate is kept at a predetermined location to fit the paper size.
●
The paper-positioning-plate motor (M4) drives the paper-positioning plate. The position of the
plate is identified by the number of motor pulses coming from the paper-positioning-plate home
position sensor (PI7).
●
The feed rollers and the crescent roller handle paper are moved by the inlet roller and held in a
predetermined position.
●
The feed plate moves paper through the accessory by coming into contact with or moving away
from paper as needed.
●
The alignment plates order the stack when paper is output. The alignment motor (M5) drives the
alignment plates. The position of the alignment motor (M5) is identified by the number of motor
pulses sent from the alignment-plate home-position sensor (PI5).
ENWW Booklet maker and booklet maker with hole punch 171
To Next Page
Loading...