Booklet maker intermediate-process-tray assembly
Stack job offset
The job-offset operation offsets the paper stack to the front or rear when ejecting to sort the paper
stack. The forward/backward movement of the sheet delivered to the processing output bin is
controlled by the front-aligning plate and rear-aligning plate. The aligned copies are stapled or ejected
according to the signal from the product. When the power is turned on, the stacker controller PCA
drives the aligning plate front motor (M103) and aligning-plate rear motor (M104) to return the two
aligning plates to the home position. The name and function of motors and sensors used by the stack
job-offset function are shown below.
Figure 1-163 Motors and sensors for stack job offset
Paper
Light-shielding plate
Rear aligning plate
home position sensor (P107)
Front aligning plate
home position sensor (P106)
Light-shielding plate
(FRONT)
Front aligning plate motor (M103)
Rear aligning plate motor (M104)
Aligning plate
(front)
Aligning plate (rear)
Figure 1-164 Stack job offset example
Results Delivering 4 sets
Direction of delivery
1st set
2nd set
3rd set
4th set
192 Chapter 1 Theory of operation ENWW
To Next Page
Loading...