Redial manually
1. Load the document into the automatic document feeder (ADF) input tray.
2. On the control panel, press Redial.
3. Press Start Fax.
4. If you have more pages to scan, press 1 to select Yes, and then repeat step 3 for each page of the
fax job.
-or-
If you are finished, press 2 to select No.
The product sends the fax to the number that it redialed. If the number is busy or does not answer, the
product redials the number based on its redial setting. If all redial attempts fail, the product updates the
fax activity log by adding the error.
Use speed dials and group-dial entries
Send a fax by using a speed dial
1. Load the document into the automatic document feeder (ADF) input tray.
2. Press the one-touch key for the speed dial.
-or-
Press Phone Book, use the alphanumeric buttons to specify the speed-dial entry, and then press
OK.
3. Press Start Fax.
4. If you have more pages to scan, press 1 to select Yes, and then repeat step 3 for each page of the
fax job.
-or-
If you are finished, press 2 to select No.
When the last page of the fax has exited the product, you can start sending another fax, copying, or
scanning.
You can assign a speed dial to numbers that you use regularly. See
Create and edit speed dials
on page 82. If you have electronic phone books available, you might be able to use them to select
recipients. Electronic phone books are generated by using third-party software programs.
Send a fax by using a group-dial entry
1. Load the document into the automatic document feeder (ADF) input tray.
2. Press the one-touch key for the group.
-or-
Press Phone Book, use the alphanumeric buttons to specify the group-dial entry, and then press
OK.
102 Chapter 10 Fax ENWW
To Next Page
Loading...