Change fax settings
Set the sound-volume settings
Control the volume of the fax sounds from the control panel. You can make changes to the following
sounds:
●
The fax sounds that are associated with incoming and outgoing faxes
●
The ring for incoming faxes
The factory-set default for the fax-sounds volume is Soft.
Set the alert volume
1. Press Setup.
2. Use the arrow buttons to select System setup, and then press OK.
3. Use the arrow buttons to select Volume settings, and then press OK.
4. Use the arrow buttons to select Alarm volume, and then press OK.
5. Use the arrow buttons to select Off, Soft, Medium, or Loud.
6. Press OK to save the selection.
Set the fax-sounds (phone-line) volume
Complete the following steps to change the fax-sounds volume.
1. Press Setup.
2. Use the arrow buttons to select System setup, and then press OK.
3. Use the arrow buttons to select Volume settings, and then press OK.
4. Use the arrow buttons to select Phoneline volume, and then press OK.
5. Use the arrow buttons to select Off, Soft, Medium, or Loud.
6. Press OK to save the selection.
Set the ring volume
When the product is initially receiving a call, a ring alert is audible. The ring duration length is based on
the local telephone company ring-pattern length. The factory-set default for the ring volume is Soft.
1. Press Setup.
2. Use the arrow buttons to select System setup, and then press OK.
3. Use the arrow buttons to select Volume settings, and then press OK.
4. Use the arrow buttons to select Ring volume, and then press OK.
5. Use the arrow buttons to select Off, Soft, Medium, or Loud.
6. Press OK to save the selection.
86 Chapter 10 Fax ENWW
To Next Page
Loading...