9
6
EN
Windows installation for networked products (wired or wireless):
1. Wired networks only: Connect the network cable to the product and the network.
2. Wireless networks only: Make sure that the PC you are installing on has access to the wireless network.
TIP: For more information about wireless installation, go to www.hp.com/global/us/en/wireless/index.html.
3. Wired and wireless networks: Insert the CD into the computer and follow the software installation instructions. When prompted,
choose Connect to a wired network or Connect to a wireless network.
NOTE: If the CD does not run, click the Windows Start button, select Computer (or My Computer), double-click the CD drive, and then
double-click the Autorun.exe program to launch it.
NOTE: If the installation program does not detect the product on the network, you may need to do one of the following:
a. Wired networks only: enter the IP address for the product manually. To nd the IP address, touch the Setup button, touch Reports, and
then touch Conguration Report. The IP address is listed on the rst page of the report.
b. Wireless networks only: You may be requested to temporarily connect a USB cable from your PC to the device to allow the installation
program to obtain the needed wireless settings.
4. The installation is complete.
在 Windows 中安装联网产品（有线或无线）：
1. 仅限有线网络：将网线连接至本产品和网络。
2. 仅限无线网络：确保安装产品的 PC 接入了无线网络。
提示：有关无线安装的详细信息，请访问 www.hp.com/global/us/en/wireless/index.html。
3.
有线和无线网络：将 CD 放入计算机，然后按软件安装说明进行操作。出现提示后，选择连接到有线
网络或连接到无线网络。
注：如果该 CD 不运行，则单击 Windows 开始按钮，选择计算机（或我的电脑），双击 CD 驱动器，然后 双
击
Autorun.exe 程序以启动它。
注：如果安装程序没有在网络上检测到本产品，则可能需要执行以下某项操作：
a. 仅限有线网络：手动输入本产品的 IP 地址。要查找该 IP 地址，请依次轻触设置按钮、报告、配置报告。
报告的第一页上列出了该 IP 地址。
b. 仅限无线网络：可能要求您临时用 USB 电缆将 PC 连接到设备，以使安装程序可获取所需的无线设置。
4. 安装完毕。
ZHCN
To Next Page
Loading...