Wireless Configuration
Use the Wireless Configuration page to turn off/on the wireless capabilities for the product.
Figure 2-38 HP Device Toolbox, Networking tab – Wireless Configuration page
Network Identification
Use the Network Identification pane to configure the host name and domain name(s) used to
identify the product on the network.
The values for host name and domain names are retrieved from the firmware, and displayed on this
pane. The Networking firmware determines what host name and domain name(s) to use.
The information under Available Host name / Domain names is for information only and cannot be
modified.
The text entries are disabled under certain circumstances. The following table defines when the
entities are disabled:
Table 2-8 Network Identification page – Text Entities
Text Entity Disabled status
Host name Disabled if configured by BOOTP
Domain name (IPv4/IPv6) Disabled if configured by BOOTP, DHCPv4, or DHCPv6
86 Chapter 2 Windows software description and installation ENWW
To Next Page
Loading...
Need help?
General
