Document feeder base assembly
Before proceeding, remove the following components:
●
Document feeder tray. See
Document feeder input tray on page 77.
●
Document feeder cover. See
Document feeder cover on page 78.
●
Document feeder core. See
Document feeder core assembly on page 82.
Remove the document feeder base assembly
1. Release the adhesive FFC protector on the document feeder base (callout 1).
TIP: Use two-sided tape to replace the FFC protector during reassembly.
Figure 1-132 Remove the document feeder base assembly (1 of 3)
1
ENWW Removal and replacement procedures 85
To Next Page
Loading...
