HP LASERJET PRO M1530 - Page 71

4. Release two tabs (callout 1), and then slightly separate the motor driver PCA (callout 2) from the
product.
CAUTION: The motor driver PCA is still connected to the product by the wire harnesses and
an FFC.
Figure 1-75 Remove the main motor (4 of 9)
2
1
5. Duplex models only: Release one tab (callout 1), and then remove the duplex connector PCA
(callout 2).
Figure 1-76 Remove the main motor (5 of 9)
1
2
ENWW Removal and replacement procedures 51