2. Remove four screws (callout 1), and then remove the laser scanner cover (callout 2) and the
sheet-metal plate (callout 3).
NOTE: The laser scanner cover and plate are removed as one assembly.
TIP: Make sure that the black screws (callout 4) are installed in the correct holes when
reinstalling the laser scanner cover.
Figure 1-73 Remove the main motor (2 of 9)
1
2
3
4
3. Disconnect three connectors (callout 1 and callout 2).
Figure 1-74 Remove the main motor (3 of 9)
1
2
50 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
