2. Remove four screws (callout 1), and then remove the laser scanner cover (callout 2) and the
sheet-metal plate (callout 3).
NOTE: The laser scanner cover and plate are removed as one assembly.
TIP: When installing the laser scanner cover, make sure that the black screws (callout 4) are in
the correct holes.
Figure 1-115 Remove the duplex connector PCA (2 of 5)
1
2
3
4
3. Disconnect three connectors (callout 1)
Figure 1-116 Remove the duplex connector PCA (3 of 5)
1
ENWW Removal and replacement procedures 75
To Next Page
Loading...
