4. Release two tabs (callout 1), and then slightly separate the motor driver PCA (callout 2) from the
product.
CAUTION: Do not damage the FFC and the connectors that are still connected to the motor
driver PCA.
Figure 1-117 Remove the duplex connector PCA (4 of 5)
2
1
5. Release one tab (callout 1), and then remove the duplex connector PCA (callout 2).
Figure 1-118 Remove the duplex connector PCA (5 of 5)
1
2
76 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
