Scanner assembly
Before proceeding, remove the following components:
●
Paper-delivery tray. See
Paper-delivery tray (output bin extension) on page 12.
●
Left cover. See
Left cover on page 13.
Remove the scanner assembly
NOTE: The M127fw and M128fw models are shown in the following photos. Other models look slightly
different, but the procedure is the same. For photos that show the differences, see
Left-side PCAs
on page 33.
1. Disconnect the scanner FFC (callout 1).
M127 and M128 models only: Disconnect one wire harness connector (callout 2), and remove it from
the cable guide (callout 3).
Figure 1-19 Remove the scanner assembly (1 of 4)
1
3
2
14 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
