Light status State of the product Action
Attention light is blinking, and ready
light is off.
The product has experienced an error that
can be corrected at the product, such as
a jam, an open door, the absence of a
print cartridge, or the absence of paper in
the proper tray.
Inspect the product, determine the error,
and then correct the error. If the error is
the absence of paper in the proper tray or
the product is in a manual feed mode, put
the proper paper in the tray and follow the
on-screen instructions, or open and close
the print-cartridge door to resume
printing.
Attention light is blinking, and ready
light is on.
The product has experienced a continual
error from which it can recover on its own.
If the recovery is successful, the product
continues to the processing data state
and completes the job.
If the recovery is unsuccessful, the
product continues to the continuable
error state. Try removing any paper from
the paper path and turning the product
power off, and then on again.
The attention and ready lights are on. The product has experienced a fatal error
from which it cannot recover.
1. Turn off the product or disconnect
the power cord from the product.
2. Wait 30 seconds, and then turn on
the product or reconnect the power
cord to the product.
3. Wait for the product to initialize.
4. If the error persists, contact
customer support for more
information. See
Customer support
on page 164.
The wireless light is blinking. The product is attempting to locate a
wireless network.
No action is required.
Table 3-3 Control-panel light patterns (continued)
ENWW Tools for troubleshooting 105
To Next Page
Loading...