Duplex-reverse solenoid, duplex product
Before proceeding, remove the following components:
●
Main-input tray. See
Main-input tray on page 43.
●
Output bin tray extension. See
Output bin tray extension on page 44.
●
Left cover. See
Left cover, duplex product on page 47.
●
Right cover. See
Right cover, duplex product on page 52.
●
Control panel. See
Control panel on page 59.
●
Front cover. See
Front cover on page 61.
Remove the duplex-reverse solenoid
1. Release one tab (callout 1), and then remove the holder (callout 2).
Figure 2-108 Remove the duplex-reverse solenoid (1 of 5)
1
2
104 Chapter 2 Removal and replacement ENWW
To Next Page
Loading...