2. Remove four screws (callout 1), the scanner cover (callout 2) and the sheet-metal plate (callout 3).
NOTE: The scanner cover and plate are removed as one assembly.
TIP: When the cover is reinstalled, make sure that the black screws (callout 4) are installed in
the correct screw holes.
Figure 2-119 Remove the duplex-connector PCA (2 of 5)
1
2
3
4
3. Disconnect three connectors (callout 1)
Figure 2-120 Remove the duplex-connector PCA (3 of 5)
1
ENWW Main assemblies 111
To Next Page
Loading...