4. Release two tabs (callout 1), and then slightly separate the motor driver PCA (callout 2) from the
product.
CAUTION: The motor driver PCA is still connected to the product by the wire harnesses and a
FFC.
Figure 2-121 Remove the duplex-connector PCA (4 of 5)
2
1
5. Release one tab (callout 1), and then remove the duplex-connector PCA (callout 2).
Figure 2-122 Remove the duplex-connector PCA (5 of 5)
1
2
112 Chapter 2 Removal and replacement ENWW
To Next Page
Loading...