Table 3-3 Control-panel lights
Light status Light pattern State of the product Action
All lights are off
NOTE: The power button backlight is
off.
The product is in
Auto-Off mode or is
turned off.
Press the power
button to deactivate
the Auto-Off mode or
turn on the product
All lights are off
NOTE: The power button backlight is
on.
The formatter is not
connected to the
product correctly.
1. Turn off the
product.
2. Wait
30 seconds, and
then turn on the
product.
3. Wait for the
product to
initialize.
4. Make sure that
the formatter
connectors are
fully seated. If
the error
persists,
replace the
formatter. See
Formatter PCA
on page 67.
Attention , ready , and go
lights cycle. Toner light is off.
NOTE: The power button backlight is
on.
The formatter is
initializing.
No action required.
Wait for the
initialization period to
end. The product
enters the Ready
state when the
initialization period is
finished.
ENWW Tools for troubleshooting 129
To Next Page
Loading...