Light status Light pattern State of the product Action
All lights cycle.
NOTE: The power button backlight is
on.
The product is
processing a cleaning
page.
No action required.
Wait for the cleaning
process to end. The
product enters the
Ready state when the
cleaning process is
finished.
Ready light is on, and all other
lights are off.
NOTE: The power button backlight is
on.
The product is in the
Ready state.
No action required.
The product is ready
to receive a print job.
Ready light is blinking, and all other
lights are off.
NOTE: The power button backlight is
on.
The product is
receiving or
processing data.
No action required.
The product is
receiving or
processing a print
job.
To cancel the current
job, press the cancel
button
.
Attention light is blinking, and all
other lights are off.
NOTE: The power button backlight is
on.
The product has
experienced an error
that can be corrected
at the product, such
as a jam, an open
door, or the absence
of paper in the proper
tray.
Inspect the product,
determine the error,
and then correct the
error. If the error is
the absence of paper
in the proper tray or
the product is in a
manual feed mode,
put the proper paper
in the tray and follow
the on-screen
instructions, or open
and close the print-
cartridge door to
resume printing.
Table 3-3 Control-panel lights (continued)
130 Chapter 3 Solve problems ENWW
To Next Page
Loading...