EN
Error Codes –
23
1
All Printers
• The paper tray is empty or is seated incorrectly.
• The sensor arm is stuck or broken.
• The tray-size sensing or configuration is defective.
– Verify the tray tabs and switches are at the right rear (or right
front) of the tray slot, or configure the tray from the control panel.
• The paper control/sensor PCA is defective.
4L
• The paper cassette is empty or missing.
• The paper cassette is seated incorrectly.
• The paper out flag PS2 is broken or stuck.
• The DC controller PCA is defective.
• Tray 1 (the MP tray) is empty.
– Add paper to Tray 1; then press
[Go]
to continue.
• Tray 2 (the paper cassette) is empty.
– Add paper to the tray if it is on continuously; verify that the
sensor flag movement is not hindered.
11 Paper Out (MP/PC/UC/LC/EC/LE LOAD)
To Next Page
Loading...
Need help?
General
