22 – Control panel messages
EN
5Si, 5
• Separate all accessories.
• Power cycle the printer.
• The formatter PCA is defective.
• The DC controller is defective.
• The power supply is defective.
4V
• The Input/Output (I/O) cable is hooked up incorrectly or there is bad
I/O in the computer.
– Remove the I/O cables and power cycle the printer.
• There are defective component(s).
– Replace the fusing assembly if it is not warming up the DC
controller, PCA power supply, or formatter PCA.
4Si/IIISi
• The display cable or formatter PCA is defective.
IID, II
• The I/O cable is hooked up incorrectly or there is bad I/O in the
computer.
– Remove the I/O cables. Replace the formatter PCA.
2686A/D
• The DC power supply/main motor drive is defective.
Warming Up
02 Warming Up (if 3 Minutes)—See also
50 Error
To Next Page
Loading...
Need help?
General
