EN
Error Codes –
33
1
All Printers
• The toner in the toner cartridge is uneven.
• The toner cartridge contact points are malfunctioning.
• The HV power supply is defective.
4Si, IIISi
• The door-open sensor flag is defective.
– Replace the PS1.
• The toner level sensor connector is damaged.
– Replace the toner level sensor.
• The toner cartridge is defective.
• The DC controller PCA is defective.
III, II
• The cable is defective.
– Replace the DC controller to the HV power supply cable
(part number RG1-0906-000CN).
All Printers
• The printer is not connected to an active LAN.
– Connect the printer to a LAN or terminate the connection, using
a BNC T-connector with two 50-ohm resistors.
• The MIO card is misaligned or defective.
– Reseat or replace the MIO card.
16 Toner Low
18 MIO Not Ready
To Next Page
Loading...
Need help?
General
