34 – Control panel messages
EN
All Printers
• The error message remains on after 5 minutes.
– Check the network card or host.
All Printers
• A large print job exceeds memory capacity.
– Verify that the SIMMs are seated. Add memory, remove soft
fonts, decrease resolution, or simplify the print job. Adjust the
settings for Image Adapt and Page Protect, if available.
6L/5L
• Set the enhanced input/output (I/O) to auto mode (printer command
language [PCL] mode).
– Re-send the print job. If the auto-continue variable is on within
the printer job language (PJL), the printer will continue to print
after 10 seconds. If it is off, press the front panel button to
continue printing.
LJ 5
• There is too much data or the data is too complex.
– Turn Image Adapt and Page Protect to On or Auto. (This can be
set within the remote control panel.) Press [Go] to resume
printing.
18 MIO Initialization
20 Error/Memory Overflow
To Next Page
Loading...
Need help?
General
