64 – Control panel messages
EN
All Printers
• The formatter PCA is defective.
• A temporary error has occurred.
– Press ]Continue] and check the control menu settings. Then,
power cycle the printer.
6P, 5P
• (68 SERVICE) -NVRAM full.
– Perform a nonvolatile random-access memory (NVRAM)
initialization by holding down [Reset] for more than 20 seconds
while turning on the printer.
5Si, 6P, 5P, 5
• (68 Error) - error in NVRAM.
– Check the control panel settings. Replace the formatter PCA if
the problem persists.
5Si, 5
• (68 SERVICE) -NVRAM full.
– Power cycle the printer. If the problem persists, perform a
NVRAM initialization by holding down [Item] or [Job Cancel] on
the LJ 5) while turning the printer on. All control panel settings
(including service mode settings) must be reset after this
procedure.
4P, 4 Plus, 4
• (68 Error) There is an error in the NVRAM.
– Check the control panel settings. Replace the formatter PCA if
the problem persists.
68 Error/Service
To Next Page
Loading...
Need help?
General
