1 Safety precautions
Before using your printer, read the following safety precautions to make sure you use the equipment safely.
You are expected to have the appropriate technical training and experience necessary to be aware of hazards
to which you may be exposed in performing a task, and take appropriate measures to minimize the risks to
yourself and to other people.
General safety guidelines
●
There are no operator-serviceable parts inside the printer except those covered by HP's Customer Self
Repair program (see
http://www.hp.com/go/selfrepair/). Refer servicing of other parts to qualified
service personnel.
●
Turn off the printer and call your service representative in any of the following cases.
◦
The power cord or plug is damaged.
◦
The curing enclosures are damaged.
◦
The printer has been damaged by an impact.
◦
There is any mechanical or enclosure damage.
◦
Liquid has entered the printer.
◦
There is smoke or an unusual smell coming from the printer.
◦
The printer has been dropped or the curing module has been damaged.
◦
The printer is not operating normally.
●
Turn off the printer in either of the following cases.
◦
During a thunderstorm
◦
During a power failure
●
Take special care with zones marked with warning labels.
Electrical shock hazard
WARNING! The internal circuits of curing zones, output drier, print zone heaters and built-in power
supplies operate
at hazardous voltages capable of causing death or serious personal injury.
The printer uses two power cords. Unplug both power cords before servicing the printer.
ENWW General safety guidelines 1
To Next Page
Loading...
Need help?
General
