Need help?Do you have a question about the HP Latex 54 Cutter and is the answer not in the manual?
General| Cutting Speed | Up to 113 cm/sec diagonal |
|---|---|
| Cutting Force | Up to 400 g |
| Connectivity | USB, Ethernet |
| Maximum Media Width | 54 inches |
| Media Types | Vinyl, paper, film, fabric |
| Compatibility | HP Latex printers |
| Power Requirements | 100-240 V, 50/60 Hz |
Provides an overview of the cutter's features and capabilities.
Essential safety guidelines for using the cutter to prevent injury.
Step-by-step guide for loading substrate rolls into the cutter.
Instructions for loading substrate sheets into the cutter.
Process to calibrate the substrate for accurate marker recognition by the OPOS sensor.
How to fine-tune settings like knife depth and pressure for optimal cutting.
Guides on setting knife depth and pressure for different substrates.
Instructions for adjusting the cutter's speed parameters for efficient operation.
How to adjust the cutter's velocity, affecting its movement speed.
Accessing and using various system setup menus for configuration.
Options for configuring LAN, Language, Units, OPOS, USB, and Alignment modes.
Detailed explanation and modification of OPOS system parameters.
Step-by-step guide for safely removing and installing the cutting knife.
Setting the correct offset for the knife tip to ensure cutting accuracy.
Solutions for problems related to unsatisfactory cutting quality.
Troubleshooting steps for substrate drifting and tracking problems.
Guidance on resolving issues where the substrate jams during operation.
How to fix problems with the cutter not detecting HP barcodes or registration marks.
Procedure to calibrate the OPOS sensor for optimal performance.
To Next Page
