Need help?Do you have a question about the HP Latex 64 Cutter and is the answer not in the manual?
General| Cutting Width | 1651 mm |
|---|---|
| Connectivity | Ethernet |
| Media Types | Vinyl, paper, film |
| Maximum Media Width | 1.65 m (65 in) |
| Software | HP FlexiPrint and Cut RIP |
| Compatible Operating Systems | Windows 7, Windows 8, Windows 10 |
| Power Requirements | AC 100-240 V (±10%), 50/60 Hz (±3 Hz) |
Essential safety guidelines for operating the cutter to prevent injury or damage.
Identifies and describes the primary physical parts of the cutter.
Step-by-step instructions for powering the cutter on and off.
Guidance on establishing a connection between the cutter and a computer.
Details the cutter's control interface, keys, and display.
Instructions for loading substrate material from a roll.
Process to ensure the sensor reads markers accurately for cutting.
Fine-tuning settings like knife depth and pressure for optimal cuts.
Calibrating the cutter for precise cut length accuracy.
Step-by-step guide for removing and installing the cutting knife.
Solutions for issues resulting in poor cut quality.
Diagnosing and resolving problems with substrate tracking.
Troubleshooting and fixing issues causing substrate jams.
Resolving problems with the cutter not detecting barcodes or marks.
Performing OPOS sensor calibration for accuracy.
To Next Page
