Change parameter values for a user
1. Turn on the cutter.
2.
Press .
3.
Press . System setup appears on the screen. Press .
4.
Press or to scroll through the menu until you reach Conguration. Press .
5.
Press or to scroll through the menu until you reach User. Press .
6.
Press again. The currently selected user name appears on the screen.
7.
Press or to change the user.
8.
Press to conrm. An asterisk appears by the user name, indicating that it is now selected.
9.
Press twice to leave the menu.
NOTE: Velocity is the main speed parameter. The default value for the three other parameters is AUTO. This
means that they are linked to velocity (which is the speed when the tool is down). The AUTO parameters can be
set individually, but will then cease to be linked to the velocity parameter.
22 Chapter 3 Load the substrate ENWW
To Next Page
Loading...
