9. Check that the result is satisfactory. If not, change one of the above parameters. Reducing the velocity can
improve the result. You are recommended never to use cutting speeds greater than 400 mm/s (16 ips) with
cutting pressures above 170 g.
NOTE: It is not always easy to nd the correct balance between cutting deep enough (ensuring that the
pieces can be taken out easily) and not cutting too deep (ensuring that the substrate keeps its strength
while cutting). Sometimes this balance does not exist, meaning that this substrate cannot be cut through
with satisfactory results.
NOTE: FlexCut parameters are always metric, regardless of the value of the Units parameter.
TIP: When cutting through, parallel lines are recommended to be at least 1 cm away from each other.
Otherwise, while cutting the second line, the rst line may come loose and cause trouble.
10.
Press to conrm.
11.
Press to leave the FlexCut menu.
12.
Press or to scroll through the menu until you reach Panels. Press .
13.
Press or to choose the panel parameter to be changed.
14.
Press or to change the value of the chosen parameter.
TIP: Recommended settings are: Panels: On; Panel size: 3–10 cm; Recut: O; Sorting: On.
15.
Press to conrm. An asterisk appears by the value, indicating that it is now selected.
16.
Press twice.
ENWW Detailed OPOS operations 31
To Next Page
Loading...
