3 Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
Installing the Monitor Base
To install the monitor base:
1. Place the base on a smooth, flat surface.
2. Align the pedestal column on top of the base and press down to install.
3. Using both hands, position the monitor over the pedestal base.
NOTE: Do not install the base if the monitor will be used on a wall, swing arm, or other
mounting fixture; instead see
Mounting the Monitor on page 8 in this chapter.
4. Press down firmly to lock the pedestal base in place. When the base locks, it will make a clicking
sound.
NOTE: Be sure the pedestal base is securely locked before continuing with the setup.
Figure 3-1 Inserting the Monitor into the Pedestal Base
Installing the Monitor Base 5
To Next Page
Loading...
Need help?
General
