Using the Auto-Adjustment Function
You can optimize the screen performance for the VGA (analog) input by using the Auto/OK button on
the monitor.
This procedure can correct the following image quality conditions:
● Fuzzy or unclear focus
●
Ghosting, streaking or shadowing effects
●
Faint vertical bars
● Thin, horizontal scrolling lines
● An off-center picture
To use the auto-adjustment feature:
1. Allow the monitor to warm up for 20 minutes before adjusting.
2. Press the Auto/OK button on the monitor front panel. You can also press the Menu button to
open the OSD window, then select the Image Control, followed by Auto-Adjustment.
Using the Auto-Adjustment Pattern Software (Select Models)
If a CD is provided with your monitor, use the Auto-Adjustment Pattern software provided on the CD
to improve the screen image.
1. Insert the CD in your computer CD drive. The CD menu is displayed.
2. Select the language.
3. Select Open Auto-Adjustment Software. The setup test pattern displays.
4. Press the Auto/OK button on the monitor front panel to produce a stable, centered image.
5. Press the ESC key or any other key on the keyboard to exit the test pattern.
Adjusting the Monitor Settings 17
To Next Page
Loading...
Need help?
General
