Control-panel assembly
CAUTION: The control-panel is an ESD-sensitive component.
1. Remove the control-panel bezel. See Control-panel bezel on page 81.
2. Push in on the control-panel assembly latch (callout 1), and then slide the assembly to the left to
release it.
Figure 5-16 Remove the control-panel assembly (1 of 2)
3. Slightly lift up the control panel and disconnect one FFC (callout 2). Remove the control-panel
assembly.
CAUTION: Do not bend or fold the FFCs during the removal or reinstallation process.
Figure 5-17 Remove the control-panel assembly (2 of 2)
2
82 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...