Drive-gear assembly and drive belt
1. Release one tab (callout 1). Rotate the paper-pickup drive shaft locking clip until the clip retainers
align with the holes in the chassis, and then remove the clip.
Figure 5-102 Remove the Drive-gear assembly and drive belt (1 of 4).
1
2. Carefully slip the drive belt off of the motor shaft (callout 2) and then remove four screws (callout 3).
Figure 5-103 Remove the Drive-gear assembly and drive belt (2 of 4).
3
2
ENWW Product base 135
To Next Page
Loading...