3. Remove the drive-gear assembly.
CAUTION: Not all of the gears and springs are captive when you remove the drive-gear
assembly. Make sure that you do not loose any of the springs or gears when the assembly is
removed.
Figure 5-104 Remove the Drive-gear assembly and drive belt (3 of 4).
4. Remove one gear (callout 4) and carefully slip the drive belt (callout 5) off of the drive gear.
TIP: When you reinstall the main-motor drive belt, make sure that it is correctly positioned on top
of the spring loaded tension idler and that it is not twisted (the groves in the belt should face inwards
when the belt is correctly positioned.
Figure 5-105 Remove the Drive-gear assembly and drive belt (4 of 4).
4
5
136 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...