Default Copy Options
NOTE Values shown with “(default)” are the factory-default values. Some menu items have no
default.
Table 2-3 Default Copy Options menu
Menu item Sub-menu item Values Description
Number of Copies Type the number of
copies. The factory
default setting is 1.
Set the default number of copies for a copy job.
Number of Sides 1 (default)
2
Set the default number of sides for copies.
Collate Off
On (default)
Set up options for collating sets of copies. When you
make multiple copies of a document, collating places
the pages in the correct order, one set at a time, rather
than placing all copies of each page next to each other.
Edge-To-Edge Normal (recommended)
(default)
Edge-To-Edge Output
If the original document is printed close to the edges,
use the Edge-To-Edge feature to avoid shadows that
can appear along the edges. Combine this feature with
the Reduce/Enlarge feature to ensure that the entire
page is printed on the copies.
20 Chapter 2 Control panel ENWW
To Next Page
Loading...
