Oblique-roller assembly
1. Remove the following components:
●
Left-side cover (see
Left-side cover on page 97)
●
Back cover (see
Back cover on page 101)
●
I/O cover (see
I/O cover on page 103)
●
Duplexer inlet guide (see
Figure 5-61 Removing the fuser (1 of 3) on page 139)
●
Access plate (see
Access plate on page 144)
2. At the bottom of the device, remove the two screws (callout 1) that secure the oblique-roller
assembly to the device, and then lift the assembly from the device.
1
Figure 5-68 Removing the oblique-roller assembly
146 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...