3. At the back of the device, press one tab (callout 1) to release the access plate, and then lower the
access plate until the other side slides off of the other tab (callout 2).
NOTE You might have to pry the tab with a flat-blade screwdriver. If you bend the tab,
straighten the tab before you reinstall the plate.
1
2
Figure 5-67 Removing the access plate (2 of 2)
4. Slide the plate out of the device.
CAUTION Make sure that you do not damage the spring that is attached to the plate.
ENWW Access plate 145
To Next Page
Loading...