Left-side fan
1. Remove all of the covers (see Covers on page 94) and the ADF/scanner assembly (see Scanner
assembly on page 90).
2. Disconnect the left-side-fan cable from the ECU.
3. Remove two screws (callout 1) at the left side of the device and then lift the fan plate and fan straight
away from the hole in the chassis.
NOTE Do not disconnect the left-side-fan cable from the fan. Instead, unroute the fan cable
starting at the ECU connector.
1
Figure 5-70 Removing left-side fan
148 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...