High-voltage power supply (HVPS)
1. Remove the following components:
●
All covers (see
Covers on page 94) and the ADF/scanner assembly (see Scanner
assembly on page 90)
●
Fax accessory (see
Fax accessory on page 111)
●
Disk drive (see
Disk drive on page 113)
●
Formatter (see
Formatter on page 116)
●
Stapler (see
Stapler on page 117) and stapler power-supply (see Stapler power-supply
on page 123)
●
ECU (see
Engine control unit (ECU) on page 131)
●
Left-side riser (see
Left-side riser on page 138)
●
Access plate (see
Access plate on page 144)
●
Oblique-roller assembly (see
Oblique-roller assembly on page 146)
●
Left-side fan (see
Left-side fan on page 148)
Tip You do not have to unroute the left-side-fan cable in order to remove the HVPS.
After removing the fan from its hole in the chassis, simply set the fan down on the
workspace.
2. Tip the device so that it rests on its top.
ENWW High-voltage power supply (HVPS) 149
To Next Page
Loading...