3. Remove cables from four cable guides (callout 2) and then remove four screws (callout 3) from the
gear-assembly plate.
NOTE Make sure that you duplicate the cable routing when you reinstall the assembly.
2
33
Figure 5-82 Removing the gear assembly (2 of 2)
4. Pull the gear assembly straight away from the device.
NOTE The spring (callout 4 in Figure 5-83 Reinstalling the gear assembly on page 165)
is not attached to the gear-assembly plate or to the large gear. As a result, the spring might
fall out of the device when you remove the gear assembly.
164 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...