Reinstallation notes for the gear assembly
Reinstallation tip Close the cartridge door and press the large gear against the device chassis
before you start to reinstall the gear assembly.
Reinstallation tip The spring (callout 4) has a locating pin that must be inserted into the small
hole in the gear-assembly plate before reinstallation.
Reinstallation tip Use the rod (callout 5) on the gear-assembly plate as a locator to find the
correct position for the gear assembly. Insert the rod into the hole in the lower gear on the device
chassis.
Reinstallation tip Be careful not to catch any cables behind the gear-assembly plate when
reinstalling the screws.
5
4
Figure 5-83 Reinstalling the gear assembly
ENWW Reinstallation notes for the gear assembly 165
To Next Page
Loading...